Single Medium Arch

Description

Name: Medium Arch Segments

Description:

Coro arch segments that maintain pixel or RGB node spacing while orienting the light towards the audience.

Features:

The medium Arch uses two segments of 16 pixel mounting holes at 2.125″ centers and is based on a 120cm circle. Designed to be mounted to a 25mm PVC frame for support.

• 60cm tall and 120cm wide
• 2.125″ pixel spacing
• 32 pixel/RGB Nodes per completed arch
• Made from 5mm fluted plastic (coro)
• 100% American Design, Aussie Made

Assembly:

I designed these to be used with a 25mm PVC pipe conduit found in the electrical department, two25mm PVC Tee’s, and 2ea. 1.25″ long self-tapping screws. Cut the 25mm PVC pipe 180cm long, cut the 25mm PVC conduit 112cm long. Glue the Tee’s on the ends of the PVC pipe so that you can still look through the pipe and both of the perpendicular taps of the Tee are going the same direction. Once the glue is dry, I wait overnight; you can insert the 25mm PVC conduit into the perpendicular hole of the Tee so that the PVC doesn’t block the hole of the PVC. It only sticks in about 5/8″ depending on the fitting. Now you can insert a 1.25″ long self-tapping screw to secure it. Once that is complete, bend the pipe around and secure the other end of the PVC to the EMT conduit and install a screw while still leaving the PVC pipe unblocked by the EMT. Mark the middle of the arch and place one coro arch segment on each side of the centerline. Using the ziptie holes, secure the segment to the PVC pipe by starting from the top and working your way down to the base. The coro can be manipulated to match your arc if you start from the top. Now you can install your pixels or RGB nodes. I use 3/8″ rebar or smooth bar and install a 18″ long piece into the ground and slide the PVC end over them for support in the yard. This is only one way to use the Arch segments and you can do it many other ways. Understand that the coro arch segment has no structural strength and will not hold PVC pipe in a curved shape.