Medium 360 Derek’s Dalek MiniTree
Based on Derek backus’ design of his MiniTree made of steel, we have adapted his design to a cost effective coro version.
The Medium Version of Derek’s Dalek MiniTree uses 10 panels with 10 Pixels/RGB nodes for a total of 100 nodes in a 360 configuration. You can install as many or as few nodes as you like. The tree also includes our 9″ 20 node star that is held in place with two nodes.
- 10×10 MegaTree node configuration 100 Nodes total
- Pixel spacing of 4.8cm center to center
- includes 23cm 20 node star
- Available in Black, White and Green (Green no longer available when sold out)
- Made from 5mm fluted plastic (coro)
- Mini tree is 48cm tall without star and 69cm tall with star mounted
- The base is 33cm wide and the top is 8cm wide
- At the base of each panel, an 1/8″ hole is provides to insert a stake to anchor the tree if needed
The inside of the tree has the score marks for folding. Install pixels or RGB nodes of your choice. Take the star and install the metal reinforcement rod if it isn’t already installed, make sure it is in a channel that doesn’t obstruct a node mounting hole. Then bend the star mounting tab slightly just below the star to make it straight when the tree is complete and it keeps the reinforcement from falling out. Make all wire connections now. When you are ready to close the tree, install the cableties loosely until you have them all in place then you can tighten them up to make the tree close.